GEN Exclusives

More »

Tutorials

More »
Mar 15, 2011 (Vol. 31, No. 6)

DNA, RNA, and Protein from One Sample

triplePrep Kit Allows Isolation and Purification of Three Analytes from a Single Source

  • When it comes to isolating and purifying DNA, RNA, and protein analytes, there are considerable benefits to be gained in getting all three from a single, undivided sample. These benefits include data consistency, sample preservation, and time savings. The ability to build an accurate picture of the relative levels of nucleic acids and proteins in individual tissue and cell samples brings an extra dimension to quantifying expression levels.

    GE Healthcare Life Sciences’  illustra™ triplePrep kit can perform all three purifications from a single starting sample, as part of the same protocol, which saves a significant amount of time. In addition, there are potential benefits in how much information you can get from your sample and how best to utilize the available sample material.

    The triplePrep kit uses no more sample than would be required to purify a single analyte by conventional methods, so the immediate benefit in reducing the amount of sample required is clear. If samples cannot be replaced easily or are in short supply, then isolating all three analytes in one process is a valuable alternative. Biobanks and sample libraries can be preserved, and hard-to-replace samples are utilized more effectively.

    Few samples can be said to be truly homogeneous, even two separate cell culture plates could have different expression profiles. When samples are more complex, or where a more precise understanding of expression profiles is required, the ability to isolate and purify DNA, RNA, and protein from exactly the same starting material is particularly valuable.

    Tissue samples, in particular, may contain multiple cell types, and the proportions of each cell type can vary significantly across the sample, making a reliable comparison difficult. One starting sample for all three analytes enables consistent correlation of purified DNA, RNA, and protein.

    In this article, triplePrep is compared with traditional, single-analyte, purification kits. Under these experimental conditions, the results indicate no adverse effect on either yield or purity, and improved yields in some instances.

  • Purification Process

    Click Image To Enlarge +
    Figure 1. Simple purification protocol for DNA, RNA, and protein purification can be completed in 45 minutes.

    The optimized buffer systems and purification columns developed for the triplePrep kit mean that from the user’s perspective the purification process remains simple, and will be familiar to users of existing spin column type purification kits (Figure 1). Tissue samples are first disrupted and homogenized to enable effective lysis, while cell culture samples can be mixed directly with the optimized lysis buffer provided with the triplePrep kit. Conveniently, the lysed sample can be stored at -80°C for up to six months, if required for processing at a later date.

  • DNA and RNA Isolation

    DNA is the first analyte to be captured, by passing the prepared lysate through a DNA-binding column using a simple spin procedure. The flow-through from the DNA binding column is retained, and RNA is captured next by transferring the flow-through to an RNA binding column, with a further spin procedure.

    Once again, the flow-through from the RNA binding column is retained as this contains the protein fraction, but the protocol recommends that the RNA fraction is further purified first to avoid degradation and maximize yield. RNA purification utilizes the DNase 1 supplied with the triplePrep kit and an initial treatment to remove any DNA that may have carried through from the first column is conducted with the RNA still bound to RNA binding column. An incubation of 10 minutes is sufficient to remove any remaining DNA, following which purification is achieved by washing the column with the supplied wash buffer and then eluting into a fresh RNase-free microcentrifuge tube.

    Both wash and spin steps require only a single brief spin to pass the respective buffers through the column. DNA purification is achieved using a similar approach, with two wash steps followed by a single elution. Time taken for DNA and RNA purification is no more than 10 minutes each, and experienced users can run DNA and RNA purification concurrently, further reducing the time required. If only DNA and RNA are required then the protocol can be terminated at this point.


Add a comment

  • You must be signed in to perform this action.
    Click here to Login or Register for free.
    You will be taken back to your selected item after Login/Registration.

Related content

Jobs

GEN Jobs powered by HireLifeScience.com connects you directly to employers in pharma, biotech, and the life sciences. View 40 to 50 fresh job postings daily or search for employment opportunities including those in R&D, clinical research, QA/QC, biomanufacturing, and regulatory affairs.
 Searching...
More »

GEN Poll

More » Poll Results »

New Drugs for Ebola

Do you think that biopharma companies should not have to go through the normal drug approval process in order to get potential life-saving therapies to Ebola patients more quickly?